Brodit 810771 - Telefoonhouder

Headrest mount\n\nHeadrest mount for Vesa, fits 75x75mm. Fits headrests with the following measurements between the bars: Min. inner size 95 mm, Max. outer size 211 mm.\n\nThe headrest mount is to be placed onto the front seat's headrest. You can install it yourself in a couple of minutes, installation instructions are included.\n\nIs your car missing?\nThis headrest mount fits a number of vehicles, some of them are listed below. Are you missing a model? Measure the headrest in your vehicle, if it matches the measurements below this product will fit in your car.\n\nMinimum inner size between headrest bars: 95 mm.\nMaximum outer size between headrest bars: 211 mm.\n\nINSTALLATION INSTRUCTIONS:\nPlease read all of the instructions and look at the pictures before attaching the headrest mount.\n1. Use the enlcosed tool to remove the screws in the headrest mount so you get two parts. Place the back part of the headrest mount onto the front side of the headrest. Place the other part of the headrest, equipped with a mounting plate, onto the back part of the headrest mount so the screws match the holes. Tighten the two screws a little bit, just so the headrest mount is in place.\n2. Use the other enclosed tool to loosen the screw underneath the headrest mount. Adjust the mounting plate into desired position. Tighten the screw underneath the headrest mount so the mounting plate is firmly in place.\n3. Adjust the height of the headrest mount into desired position. Tighten the screws so the headrest mount is firmly in place.\n4. The headrest mount is in place.